Видео

Hello! First of all, please note that this is NOT a DIY job! Looks easy, but is not :). If you're not an experienced installer, you should go to a Dacia dealership for the installation. This way, if something goes wrong, they are responsible and will have to fix it, plus you'll keep your product warranty. Well, in my opinion, even if you are an experienced installer, you should still go to them :). Warning: a poorly drilled hole may require replacing the entire trunk lid or an extremely costly bodywork repair. If you still decide to take on this job, the responsibility will be entirely yours. For more info, please send me an email at ovidiu.cuiesdean@falcon.ro, and I’ll send you the installation guide. Cheers, Ovidiu.

Salut! Toate detallile de instalare se gasesc in notita de montaj pe care o are orice service Dacia. Bafta!

Those are some rebar pieces bend to the tool shape by my colleagues😁😁

@@OvidiuCuiesdean I had imagined they located into something behind the plastic panel. When you pulled on them is simply brute force, just pulling the panel off its clips all at once? I’d hate to snap any of the clips and not be able to replace the panel! (Thanks for replying on a 6 year old video by the way!)

@@instantsquid, no worries mate :). There was only the pulling you see in the video and it is very important to pull both extractors at the same time. Anyway keep that in mind that your car got some years now and the clips are not new anymore ;).

Yes, it does!

Hi. There it is: Yellow and the shield cable goes to composite video signal (yellow to core and shield to shield); Black goes to GND; Red goes to reverse signal. Please let me know if you need any more info: tech.support@falcon.ro. Cheers!

Unless you have to prove something to the insurance company and you won't be able to without video... Then you will pay moooooore than 200. Cheers!

Yep! Pentru putzin.

Salut, noi nu avem nevoie sa folosim coduri pentru activare, ci doar testerul DIAG de la Dacia. Sorry.

Thank you for the appreciation. This alarm is compatible with this model of Logan/ Sandero.

Thanks, mate for your appreciation! Cheers!

Salut, scrie-mi te rog pe suport-tehnic@falcon.ro și rezolvăm.

At Dacia, the colors can vary from one batch to another, that's why it's best to check them yourself. Remove the connector, and you will see that their numbering is written right on the connector. Good luck!

Thanks a lot ❤🙏

Could be different color. Connect to Pin 2. Please see the install guide.

My pleasure! Cheers!

Hi, Yes, this is the original MediaNAV and this is the official installation method for the original supplied rear view camera. Actually there were two MediaNAV models for this Duster model (H79): - The older one and the installation is made as shown in this video: Red to pin 2 and black to ground; - And the MediaNAV Evolution that require a different set of connections where all the Camera wires are connected to the MediaNAV and ONLY if the unit is not supplied with reverse signal, a connection is made between that pin 2 from the rear right connector and the MediaNAV. Also this type require a 6V camera. You can identify your MediaNAV type as follow: Engage the reverse gear --> the display switches to the rear camera --> get the reverse off --> if the MediaNAV is displaying the rear camera for the additional 7 seconds after the reverse gear was switched off, you got the MediaNAV Evolution.

@@OvidiuCuiesdean perfect thank you so much for your help .Its the original medianav not the evolution .Wish you the best

Thanks, mate! I don't know from where the windscreen came from. I bought the bike that way. Sorry :)

@@OvidiuCuiesdean Thanks for the quick answer 🙂. Is there a label 🏷️ on the screen? Your screen looks a lot better then the ones I have found on the net.

Yes you are right, there's a manufacturer sticker. There it is: fabbriaccessori.com/en/moto/?fwp_moto_marca=kawasaki&fwp_moto_modelli=er-6n-20052008

@@OvidiuCuiesdean thanks man 🤙🏽

He, he! Multzam! Apreciez!

Any good tips for pairing the companion remote?

Glad I could help!

Just follow the procedure: 1. Press and hold the "f" button for 8 seconds. Note: If Car 2 mode is on, ignore the Car Select beep after 3 seconds. 2. Wait for the Transmit LED to light solid and the remote to beep. Release the "f" button. 3. Press the RS button for 1 second. The transmit LED will blink 3 times and beep 3 times. 4. Within 5 seconds, press and hold the "Lock" button. 5. The vehicle siren will chirp. You have now successfully learned the remote to the vehicle remote start and security system. Release the "Lock" button. 6. Press the "f" button two times to exit learn routine on the remote. The transmit LED will turn off and exit tone will sound.

@@OvidiuCuiesdean I don’t have an alarm, only remote start. My second remote must be different as well….only one light. I was able to figure it out and program it before I saw your response. Thanks again!

ovidiu.cuiesdean@gmail.com

Unfortunately I cannot help you with that. Only thing I can recommend, is to install this Ford DashCam. It's more expensive, but there's a reason for that. Actually more than one :). Cheers!

Ok! Grazie ugualmente!!!

Hi, I do not recommend to connect anything else beside this particular DVR here. This DashCam have a particular behavior and a very low current draw in stand by - under 0.1mA.

Multzam. E o idee. Poate la toamna daca n-oi vinde-o :)).

You should be able to buy it from any Directed dealer.

@@OvidiuCuiesdean Thank you for the quick response. I was discouraged from going to a directed dealer because I was under the understanding that they won't sell it to me unless I'm authorized.

​@@hackervirus56 I don't know if they'll sell you one or not, but I think you cannot find the XKL3 anywhere else..

What alarm system do you have?

@@OvidiuCuiesdean 7944v 2way

Unfortunately, no. DS4 got a different control center.

Here: www.tech-accessoires.renault.com/renault-techaxs/media?mediaTitle=title_nm-fpas-901-hjd-dag-dad-8201701559-c&mediaId=1267390

Salut, DVR-ul se poate comanda la orice reprezentanta Ford (product number: 2421817). Instalarea a fost facuta de mine, doar ca orice reprezentanta va instala DVR-ul in acelasi fel - asa zice manualul de instalare. Toate bune! Si multzam de apreciere :)!

This product should be available at any Dacia dealership. Thanks.

A dedicated one would be recommended, but do not choose a cheap one :).

Yes, that's a Viper brain you see in the video. Cheers!

Salut! Daca display-ul este negru, piesa care face iluminarea de fundal este defecta si se schimba. Ia, te rog, legatura cu colegii mei de la service. Ii gasesti in incinta Faberrom: Bulevardul Iuliu Maniu nr. 7, Bucuresti Sector 6, 061072 (in incinta APACA) Tel: 0721.288.955.

Yes, there is something better: - 8201735449 if the car got light and rain sensor, or - 8201739626 if the car do not have that sensors. Cheers!

Please check the antenna cable.

@@OvidiuCuiesdean I got a regular 2 way remote an it connects

@@kamryn7496 What is that "regular" 2 way remote? Please tell me the RPN number from the back of those 2 remotes.

I'm trying to pair a viper 7945v remote to my 350v 2 way system it has the newer style antenna

@@kamryn7496, That's why is not working: the two , 350 and 7945 are not compatible. Give me the RPN from your current working remotes, or from the Control Center (antenna) and I can recommend you some compatible remotes.

Thanks! I'm glad it helped. Yes, professional installation is required. Cheers!

You think I left some? :))))

Thanks!

Thank you for the appreciation, mate! The MediaNav is just the same. Only problems will be with the camera bracket, which will not fit and the camera angle/ installation height, which is different.

Not quite, but... :). Thanks!

You're welcome! Yes, the alarm is just the same.

@@OvidiuCuiesdean Thank you so much 🌹

You’re welcome, mate!

Pentru putin!

Salut, Bogdan. Activarea am făcut-o cu CLIP-ul, testerul de service de la reprezentanta. Toate bune!

Mulțumesc!

Salut, da, DBALL este o interfata intre alarma si masina (CAN-uil masinii).

shop.ford.co.uk/products/dashboard-camera-11-2019

Da, daca ai compresor :)). Oricum dupa ce freci cu peria, C1 curata bine reziduurile.

Am sa iau. M-am uitat la așa ceva cu vreo doi ani in urma, da’ nu ma știu de ce nu l-am luat și apoi am uitat de el. Idee buna. Mulțam!

Am luat Kettenmax-ul! Da, este altceva. Urmeaza un nou tutorial cu el si cu mobra cea noua :D :D

@@OvidiuCuiesdean da da ! Simplu de folosit, curat și îndepărtează foarte bine mizeria de pe lant!

Daa, acel Grease Ninja e super meseriaș! 10$ bine cheltuiți. Am un prieten bun, video “amator” meseriaș care se ocupa de filmare și editare: mulțam Mihai!! Mulțumim de aprecieri, Adi!

Timp sa fie! Mulțumim!

🤘🤘🤘